MIL-DTL-29469A(MC)
chip colors referenced in 3.2.1. The 1/2 inch pull strap shall
be centered to the lower edge of the cover lip. The 1 inch wide
by 5-3/4 inches long fastener tape (hook and loop) conforming to
type II, class 1 OG 106 of MIL-F-21840 shall be sewn onto the
underside of the cover lip (hook) and the corresponding front
panel (loop) to secure case flap in closed position.
3.3.2.13.2 Keepers. The carrying case shall be 2-1/4 inch nylon
webbing strip on the back and the two sides, conforming to type
VIIIc, class 2, OD-7 color of MIL-W-4088. The back shall include
two standard keepers conforming to type X, black color of
MIL-H-9890 on the back of the case for attachment to cartridge
belt. The side webbing is for optional attachment of the
accessory case. The webbing shall be sewn to the carrier
positioned in the following manner: The center of the webbing
shall be centered on the sides and back of the carrier.
3.3.2.13.3 Carrying strap. The case shall have a carrying strap
of 1 inch webbing, per Drawing 14-1-167, in accordance with class
2 of MIL-W-17337, color per chips referenced in 3.2.1. The
adjustable and detachable carrying strap shall have a minimum
length of 40 inches with each end attached to a quick release
fastener which is secured to the case with a strip of 1 inch wide
webbing conforming to type III, color per 3.2.1, sewn on to the
sides of the case (as noted in 3.3.2.13.2; also see Parts List
14-1-165). The ends of the straps shall be finished as shown in
Drawing 14-1-167. The quick release female buckles shall be
attached to the sides of the carrying case (see Drawing
14-1-181). Securing straps, with the female buckles, attached to
the carrying case shall be long enough to allow them to be easily
folded into the case, so that the top of the case covers them
when it is closed. This is to keep them from "dangling" when the
carrying strap is not used (i.e., when attached to the individual
belt- "cartridge belt").
3.3.2.13.4 Stiffeners. The inside of the carrying case shall
include polyethylene stiffeners. Front and back stiffeners size
shall be 5x6 by 1/8 inches each. Others shall be in accordance
with Drawing 14-1-165. Stiffeners shall fit into stiffener
pockets (see 3.3.2.13).
3.3.2.13.4.1 Polyethylene stiffener. The stiffener shall be
made from 0.040 + 0.007 inch thick, high density virgin
polyethylene of natural color conforming to type I, class H,
grade 3 of L-P-390, except the melt index shall be 0.10 to 1.0
10
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business