MIL-DTL-29469A(MC)
(Catholic on one side and Protestant on the other side). When
assembled, the cross and crucifix will measure approximately
6-1/2 inches (+ 1/4 inch) in height and consist of a base that
allows display in an upright manner, and allow breaking down for
storage in carrying case. The cross crucifix will have a mill
finish to inhibit reflection. Etching will be in accordance with
3.5.2. Welding will be in accordance with 3.3.3.
3.3.2.9. Oil stock. The oil stock shall be made of metal as
noted in 3.2.2. Dimensions shall be 1 inch in diameter, 3/4 inch
in height (+ 1/16 inch), with same material screw cap which
includes a cork liner inside the cap. The finger ring shall be
attached by a welded clip to the bottom of the oil stock so that
when the ring is closed against the oil stock the periphery of
the ring does not extend more than 1/16 inch from the outer
fringe edge of the oil stock. The exterior shall be of mill
finish. The oil stock shall have no markings. Welding shall be
in accordance with 3.3.3.
3.3.2.10.Pyx. The pyx shall be of sufficient size to held
between eight to 12 hosts, and be constructed of corrosion
resistant steel per 3.2.2 that will allow for field use and
require minimum cleaning. Exterior shall be of mill finish and
the interior of polished finish. It shall be in accordance with
Drawings 14-1-182, 14-1-183, 14-1-184, 14-1-185, 14-1-186 and
Parts List 14-1-182. The pyx shall have no markings. Hinge may
be welded or secured by metal fabrication. If welded on the base
or cover of the pyx, it is recommended that the hinge be centered
on the base to allow for welding. Welding shall be in accordance
with 3.3.3.
3.3.2.11.Reconciliation stole. The reconciliation stole shall be
white on one side and dark purple on the other with white trim on
both sides. This can be accomplished by attaching a smaller
piece of purple material upon a piece of larger whiter material.
Material shall be of a durable, stain resistant polyester or
nylon; white material is 1-3/4 inches wide; purple material is
1-1/2 inches wide; both purple and white pieces are 48 inches
long. A gold cross shall be embroidered thru to include both
sides on each end of the stole. The best side shall be purple.
It is 1-1/2 inches long, with a cross bar of 1 inch, placed 1/2
inch from the top of the cross. Each cross shall be embroidered
4 inches from the relative bottom of each end of the stole,
centered on each end of the stole. The crosses shall include an
embroidered circle of the same thread of 1/2 inch diameter which
8
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business