MIL-DTL-29469A(MC)
border edges shall be at least 1/8 inch.
The text shall be in
accordance with Drawing 14-1-187.
3.3.2.5. Chalice assembly (cup, base, intinction cup and paten).
The chalice assembly shall be made from corrosion resistant steel
per 3.2.2 that allows for field use without requiring special
protection or cleaning. It shall be constructed in accordance
with the Drawings 14-1-172, 14-1-173, 14-1-174, 14-1-175,
14-1-176, 14-1-177, 14-1-178, 14-1-179, 14-1-180 (see Parts List
14-1-172 and 14-1-173). The exterior of the chalice shall be
mill finished in a manner to prevent reflection, and the interior
of the chalice cup, intinction cup and paten will be a polished
finish. The paten shall fit securely over the opening of the
chalice cup to prevent foreign matter from entering in windy
conditions. The chalice and the paten shall have no markings.
3.3.2.6. Cloth, corporal. The cloth shall measure 17 inches
square (+ 1/16 inch), have hemmed edges, color per acceptable
color chips in paragraph 3.2.1, and conform to cotton material of
A-A-50356. The cloth shall have a small black cross (1 inch
high, 1/2 inch wide + 1/16 inch), embroidered in the horizontal
center, 6-1/4 inches from the bottom edge of the cloth using
embroidery thread conforming to 150/2 denier rayon, bright
luster, multifilament, black color, No. 67111 in accordance with
Drawing 14-1-191.
3.3.2.7. Cloths, purificator and finger towel. The cloths, one
for the purificator and one for the finger towel, shall be made
from cotton material conforming to A-A-50356, color per
acceptable color chips in 3.2.1, with a small black cross (no
larger than 1 inch by 1/2 inch) embroidered in the center 5
inches from the top edge of the cloth. All edges shall be
hemmed. Construction and material requirements for the cloths
shall be in accordance with Drawing 14-1-192. They shall measure
approximately 17 inches in length by 8-1/2 inches in width.
Thread will be in accordance with 3.3.2.6 for the corporal.
3.3.2.8. Cross and crucifix. The cross and crucifix shall be
made from corrosion resistant steel, in accordance with 3.2.2,
that will allow for field use without requiring special
protection or cleaning. It shall be constructed in accordance
with Drawings 14-1-168, 14-1-169, 14-1-170, 14-1-171 and
14-1-180. The base shall be constructed in accordance with
Drawings 14-1-178, 14-1-179 and Parts List 14-1-168. The cross
will accommodate both Catholic and Protestant religious usage
7
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business